Cleaning the lines after a pump failure

  • 10/09/2017 7:12 AM
    Message # 5303284

    Hello,


    My JD 310 A had a pump failure which seized it up. I replaced the pump with a used one I found, but the system was open while I repaired the crank and replaced the pulley. How can I clean the lines to make sure there is no water, rust or other material in the lines. I do not want to replace another pump.


    Please help...


    I didn't find the right solution from the Internet.

    References

    http://www.heavyequipmentforums.com/threads/cleaning-the-lines-after-a-pump-failure.68458/

    whiteboard animation examples


(c) Historical Construction Equipment Association 2013-2016
16623 Liberty Hi Road
Bowling Green, Ohio 43402
419-352-5616 - Fax 419-352-6086
info@hcea.net

Powered by Wild Apricot Membership Software